support online: +919974300810

Back To Top

Arduino 9 AXES MOTION SHIELD

Be the first to review this product

₹6,500.00
OR

Quick Overview

he Arduino 9 Axes Motion Shield is based on the BNO055 absolute orientation sensor from Bosch Sensortec GmbH which integrates a triaxial 14-bit accelerometer, a triaxial 16-bit gyroscope with a range of ±2000 degrees per second and a triaxial geomagnetic sensor with a 32-bit microcontroller running the BSX3.0 FusionLib software.

Details

The Arduino 9 Axes Motion Shield allows your Arduino to measure movement: orientation, acceleration and magnetic field.

 

The Arduino 9 Axes Motion Shield is based on the BNO055 absolute orientation sensor from Bosch Sensortec GmbH which integrates a triaxial 14-bit accelerometer, a triaxial 16-bit gyroscope with a range of ±2000 degrees per second and a triaxial geomagnetic sensor with a 32-bit microcontroller running the BSX3.0 FusionLib software.

The sensor features three-dimensional acceleration, yaw rate and magnetic field strength data each in 3 perpendicular axes.

The Arduino 9 Axes Motion Shield is based on the BNO055 absolute orientation sensor (datasheet) from Bosch Sensortec GmbH. 

The BNO055 is a System in Package (SiP), integrating a triaxial 14-bit accelerometer, a triaxial 16-bit gyroscope with a range of ±2000 degrees per second, a triaxial geomagnetic sensor and a 32-bit microcontroller running the BSX3.0 FusionLib software. 
The sensor features three-dimensional acceleration, yaw rate and magnetic field strength data each in 3 perpendicular axes. 
 
It also provides the sensor fusion signals such as 
  • Quaternion
  • Euler angles
  • Rotation vector
  • Linear acceleration
  • Gravity vector
In addition, it incorporates an intelligent interrupt engine, which allows for triggering interrupts based on
  • slow or no motion recognition
  • any motion (slope) detection 
  • high-g-detection.
The shield is TinkerKit compatible, which means you can quickly create projects by plugging TinkerKit modules to the board.
 
Description

 

Operating Voltage          5V and 3.3V

Power Consumption      50mW

The 9 Axes Motion Shield can be programmed with the Arduino software (download).

Power

The Arduino 9 Axes Motion Shield has no power jack and is powered only when attached to an Arduino board.

Input and Output

The shield features several TinkerKit input/output and communication interfaces. Connecting TinkerKit modules can simplify the creation of a project or a prototype. 

The on-board connectors are :

  • 2 TinkerKit Inputs: IN2 and IN3 (in white), these connectors are routed to the Arduino A2 and A3 analog input pins.
  • 2 TinkerKit Outputs: OUT5 and OUT6 (in orange), these connectors are routed to the Arduino PWM outputs on pins 5 and 6.
  • 2 TinkerKit TWI: these connectors (4-pin in white) are routed on the Arduino TWI interface. Both connect to the same TWI interface to allow you to create a chain of TWI devices.
Physical Characteristics

The maximum length and width of the 9 Axes Motion Shield PCB are 2.7 and 2.1 inches respectively. Four screw holes allow the board to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.

+ open/close